I had a party pig from some time ago that I dropped by accident and the main valve cracked with beer spaying out and a big mess etc. I ordered replacement parts for this pig to give it a try again. I ordered from you the main valve(spigot) with gasket, activation pump, and some pressure pouches. The old pump I had was not broken, but beer had gotten into the tubing that can't be separated from the bulb...so for sanitation purposes.
The first try (this time around) the pressure pouch did not work properly and after the 1st glass poured it trickled out etc. The 2nd try the pig was conditioning and burst yielding 2.5 gal. of beer all over the garage floor. Thankfully this was in the garage. I don't think this was an over priming error as I didn't exceed the recommended amount. The beer was 1 week in the primary and 1 week in the secondary. I did not check the gravity, so maybe it wasn't entirely finished fermenting? (although, the regular glass bottles turned out o.k.) The pig bottle did have a stress point in it from the bottle getting pressed while cleaning and leaving a small crease mark. This small imperfection spot may have been enough?
-I'm not certain I want to keep attempting to use this product, Do you sell a replacement bottle only?